AFT 100 Trencher
The AFT 100 Trencher is used to dig trenches varying from narrow, shallow slits to trenches 1200mm deep and 300mm wide in soil.
The soil so dug is moved and raised by the conveyor and loaded onto a trailer.
It is not designed for digging roads, concrete, rock or any other hard material. It should not be used where there are boulders, which cannot be raised through the width of the trench or where the digging teeth bounce over obstructions in the trench without being able to excavate them. It should not be used where there are cables, pipes or other items under ground, which may be damaged.
We can provide most of our Machinery & Plant with an operator as well should you need somebody with experience to get the work done quickly, efficiently and of course professionally.
Any questions please contact us our advise is FREE!
If this isn't the exact piece of equipment you require please click here to see our full range or contact us as we may be able to source it.
We recommended the following tractors to go with this piece of equipment:
- Case MX 135 For more information please CLICK HERE
- John Deere 6310 For more information please CLICK HERE
Specifications
| Overall length with 1.6m digging boom | 340cms |
| Overall Width 170cms centres drive wheels | 246cm |
| Weight | 1,500kgs approx |
| Digging Chain | 75mm Pitch Roller Chain. Fully demountable, Side Mounted Digging Teeth |
| Digging Blades | EN45A Silicon Manganese spring steel austempered with hard faced cutting deges. Optional tungsten carbide teeth available |
| Depth Control | Twin hydraulic rams with lock valves and individual adjustable pressure relief valves for raing and lowering. Optional laser control with Selanoid operated depth control valve available. |
| Digging Chain Drive | Mechanical drive from the tractor PTO shaft through an adjustable 4 plate friction safety clutch. |
| Power | 120HP |
| 3 Point Linkage | Category 2 or 3 |
| Rear Wheels | Must be adjustable to either 150cms or 170cms |
| PTO | 540 RPM either 6 spline or 21 spline |
| Hydraulics | A minimum supply of 35 lts/min at 160 Bar is required byt higher flows and twin pump systems can be used and offer positive advantages. |
