

Plastic Mesh is an extruded plastic mesh for the protection and reinforcement of grass and turf. The Plastic Mesh stabilises the grass and enables the grass to intertwine with the plastic mesh filaments creating a strong stable reinforced grassed surface. The plastic mesh is ideal for pedestrian and light vehicle use, overflow car parks, and airport taxi-ways.
When installing plastic mesh, it is essential that the plastic mesh should be laid down to give enough time for the grass roots to intertwine with the plastic mesh filaments (E.g. early spring). This usually takes approximately one growing season. The protected area will soon resume its natural appearance with the plastic mesh disappearing below the surface of the grass providing a stable surface that will withstand the weight of vehicles and heavy pedestrian use. The plastic mesh is available in black & green in a standard grade, and black in a heavy duty grade. Plastic Mesh Black is manufactured from 100% recycled High Density Polyethylene (HDPE), whilst Green is manufactured from virgin material with a small percentage of recycled polymer added.
Grassform Plant Hire strongly advise that newly installed TurfProtecta® slip resistant grass surfaces should be left unused until the grass has grown through the plastic net apertures and a strong interlock has been achieved – normally after a few weeks during the growing season rising to a few months out of the growing season. This is to allow the grass to fully grow through the grass reinforcement net and allow the grass sward to create the strong interlock with the mesh. If the surface is used immediately grass growth may take a longer period of time and may limit the effectiveness of the product initially.
TurfProtecta® can be used in Source Control applications as part of Sustainable Urban Drainage System (SUDS) and is the perfect alternative to impermeable paved surfaces where natural grassed traffic routes and driveways are preferred and where planning restrictions are applied or cost savings are being considered.
TurfProtecta® slip resistant grass reinforcement mesh is supplied on 2m x 30m rolls in two thicknesses (Standard 550g/m2 & Premium 660g/m2) as determined by the application and manufactured from partly recycled UV Stabilised polyethylene (Approx 20% recycled polymer)
Please note that with all plastic products, the product can become slippery on damp or wet conditions if used before any grass has grown.




| Turfprotecta® slip resistant is a cost effective solution for: | |
| Grass car parks | |
| Overflow grass car parks | |
| Pedestrian paths | |
| Disabled (DDA) access routes | |
| Light aircraft taxiways | |
| Equestrian surfaces | |
| Grass verges | |
| Caravan park access and caravan bays | |
| Front lawn parking | |
| Turfprotecta® Grass Reinforcement Grid provides: | |
| High level of grass reinforcement – up to 8 tonnes per axle (imposed load) | |
| Ideal for permanent or temporary applications | |
| Fast and cost effective installation compared to plastic paving grids | |
| No excavation or soil removal necessarily required | |
| Up to 97% improved slip resistance compared to the standard grass protection meshes | |
| Standard 550 - £138.45 (£2.30 per square metre) | |
| Mesh Aperture: 25mm x 29mm | |
| Tensile Strength: 5.9k N/m (MD). 7.1k N/m (TD). | |
| Material: HDPE 100% Recycled | |
| Roll size - 2 metres x 30 metres | |
| Premium 660 - £164.85 (£2.75 per square metre) | |
| Mesh Aperture: 22mm x 27mm | |
| Tensile Strength: 6.2k N/m (MD). 7.5k N/m (TD). | |
| Material: HDPE 100% Recycled | |
| Roll size - 2 metres x 30 metres | |